Walbro FRC-3 Fuel Pump - Industrial

In stock


Like the other pumps in the Walbro FR Series, the FRC3-1 Industrial Fuel Pump features a die-cast aluminum body with a dichromate finish. It includes a removable, cleanable internal filter and runs continuously without cycling when power is applied to the pump. Expect this pump to last over 10,000 hours under continuous use, and flow a minimum of 36 gallons per hour against a load of 4 to 6 psi. It has an impressive dry lift of 48", making it a good choice in locations where the pump must be installed high above the fuel level. The FRC3-1 replaces the Walbro 6175 fuel pump in Teleflex applications. See the other specifications below for more information.

All Walbro Marine and Industrial Fuel Pumps Feature:

  • Low Current Draw
  • Reverse-Polarity Protected up to 60 minutes
  • Self-Priming (Dry Lift) of more than 24" (120 cm)
  • Dry Run to Four Hours
  • Compatible With All Commercially-Available Pump-Grade Gasoline, Gasohol, Diesel, or Bio-Diesel
  • Operating Temperature from -40° to 155° Farenheit (-40° to 70° Celcius)
  • Protection from Transient Voltages to 100 vdc
  • US Coast Guard Approved (USCG 16623-1 and USCG 16623-2)
  • European CE Standard Approved (EN 61000-6-2 and EN 63-2100)

Additionally, all Walbro FRC-Series Pumps Feature:

  • Continuous Duty Life Over 10,000 Hours (Diesel Fuel)
  • Weight of 1.83 lbs (0.83 Kg)
  • Pump Cycles Continuously When Powered
  • Replaceable Filter


  • Voltage: 12 Volt (9.0 min – 16.0 vdc max)
  • Minimum Flow Rate: 121 liters per hour (32 gph)
  • Deadhead Pressure: 62 to 83 kPa (9.0 to 12.0 psi)
  • Maximum Current Draw: 2.3 amps
  • Life: >10,000 hours
  • Dry Lift: 48 inches (120 inches with optional outlet check valve 128-3202)
  • Compatible Fuels: No-lead regular gasoline, premium gasoline, gasoline-alcohol blends, diesel and biodiesel fuels (20% and 100%), and E85
  • Corrosion Resistance: 96 hour salt spray test (ASTM B-117)
  • Operating Temperature Range: -40ºF to 155ºF (-40ºC to 68.3ºC)
  • Reverse Voltage Protected
  • Transient Voltage Protection
  • Ground: Circuit Board is Internally Grounded to Pump Body
  • Electrical Connection: Flying Leads (2); No Connector
  • Fuse: 5 amp recommended
  • Inlet & Outlet Size: 1/8-27 NPSF
  • Inlet Filter Screen: 70 micron
  • Magnetic Trap: Standard
  • Outlet Check Valve: Yes
  • Optional Outlet Check Valve Fitting 128-3202
  • Adjustable Pressure Regulator 135-631
  • 420 micron Filter Screen

The FRC series fuel pump is designed to supply fuel for internal combustion engine applications only. It is not intended or designed for continuous operation applications such as heater or stove systems.

More Information
Part Number FRC-3
Write Your Own Review
You're reviewing:Walbro FRC-3 Fuel Pump - Industrial
Your Rating
Copyright © 2003-present WalbroFuelPumps.com, Inc. All rights reserved.